CE-300 SERIES

 Maximum Output Power vs. Ambient Temperature

1. Semiconductor case temperature must not exceed 110 ^oC.
2. Each output can deliver its rated current but total output power must not exceed
   65 watts.   
3. Semiconductor case temperature must not exceed 110 ^oC
4. Sufficient area must be provided around convection cooled power supplies to allow natural movement of air develop.
5. This product is intended for use as a professionally installed component within information technology and medical equipment.
6. A minimum load of 10% is required on output one to insure proper regulation of remaining outputs.  
7. Peak to peak output ripple and noise is measured directly at the output
   terminals of the power supply, without the use of the probe ground lead or retractable tip, 20 MHz bandwidth. 
8. This product was type tested and safety certificated using the the dielectric strength test voltages listed in Table V of UL 60950. In consideration of clause 5.2.2, care must be taken to insure the voltage applied to a reinforced insulation does not over stress basic insulation. Secondary to ground capacitors may need to be removed prior to performing a dielectric strength type test on the end product. It is highly recommended that the DC test voltages be used when performing a production-line dielectric strength test of the assembled end product. Please consult factory for further information.
9. This power supply has been safety approved and final tested using a DC
   dielectric strength test. Please consult factory before performing AC dielectric strength test.
10. Maximum screw penetration into mounting holes is .250 inches